The new spinner and folding propeller unit completes the overall picture of the RoCket.
This is a pre-assembled system consisting of: Plastic spinner in high-quality 2K paint, special folding propeller, aluminum carrier optionally with 5, 6 or 8 mm bore hole, a GRP spacer and a reset rubber. The unit has been designed in such a way that, in the event of a rough landing or a crash, the propeller is unlikely to break as long as the engine is stationary at touchdown.
Special folding propeller:The aerodynamic efficiency and the resulting low-noise operation are particularly noteworthy. Furthermore, there is an extraordinary response behavior when the motor is switched on and the direct acceleration of the model due to the direct flow on the propeller profile. This saves many a botched start, especially with "zero wind starts", because the thrust, in comparison to other propellers, is available faster than the model makes contact with the ground.
Specifications:- Diameter spinner approx. 55mm
- 14x8 propeller
- For shaft diameter 5, 6 or 8mm
