Description "UHU PLUS ENDURANCE 163G"
Please be aware that this product can only be shipped to the following countries: Austria, Germany, Switzerland, Belgium, Bulgaria, Croatia, Czech Republic, Denmark, France, Greece, Hungary, Italy, Luxembourg, Netherlands, Norway, Poland, Portugal, Romania, Serbia, Slovakia, Slovenia, Spain, and the United Kingdom,Ireland!
2-component epoxy resin adhesive solvent-free two-component adhesive on epoxy resin basis for highest loads. The working time is up to 120 minutes. UHU plus endfest 90min can be used in a wide variety of ways, especially if the joint has to withstand extreme loads. The mixing ratio is 1:1 binder and hardener (volume) in most cases. After mixing, there is a limited time - the pot life - to process the adhesives. In addition to a high final strength (up to 3000N/cm²), the adhesive bond is characterised by a very high impact strength, ageing and moisture resistance.
Features:
Processing:
Adhesive surfaces must be dry and free of dust and grease. Roughen smooth surfaces. Mix binder and hardener in a ratio of 1:1 (strands of equal length). Apply adhesive on one side, on both sides for rough materials. Join parts in a snug fit without pressing. Please observe the safety instructions in the technical data sheet as well as the safety data sheet.
Features:
- Two-component adhesive based on epoxy resin for highest loads.
- Mixing ratio binder : hardener = volume 1 : 1.
- Working time (pot life) approx. 90 minutes.
- Curing time and final strength depend on temperature.
- Adhesion is impact resistant and resistant to ageing and moisture.
- Suitable materials Metal, stone, concrete, porcelain, wood, glass and many plastics.
- Unsuitable materials Polyethylene, polypropylene, Teflon®,polystyrene, soft PVC
- Load Low, High, Medium
- Resistance Petrol, alkali, oil, acid, water
- Temperature range - 40°C to + 100°C (depending on material and construction - higher temperatures also possible. Please refer to the technical data sheet)
- Contents Tube of binder (90.5g/75ml) and tube of hardener (72.5g/75ml) as well as a mixing tray with spatula
- Chemical base Epoxy resin
- Viscosity high viscosity, medium viscosity
- Pot life approx. 90 min (at room temperature)
- Bonding technique Wet bonding
Processing:
Adhesive surfaces must be dry and free of dust and grease. Roughen smooth surfaces. Mix binder and hardener in a ratio of 1:1 (strands of equal length). Apply adhesive on one side, on both sides for rough materials. Join parts in a snug fit without pressing. Please observe the safety instructions in the technical data sheet as well as the safety data sheet.
Technical data
Quantity / Length in meters: | 163 g |
---|---|
Contents of packaging: | 90,5g Binder + 72,5g Härter |
Gefahrenhinweise: | H314, H318, H412, H315, H317, H319, H411, H302, H312 |
Sicherheitshinweise: | P101, P102, P262, P305, P351, P338, P302, P352, P273, P280, P301, P310, P501, P261 |
Art: | 2K-Klebstoffe |
Piktogramme: | GHS05, GHS07, GHS09 |