Features:
- 6 primary contacts (redundantly guided; for main functions like servos), 4 secondary contacts (single, for secondary functions like light)
- 3000 mating cycles, 10A for primary contacts, 5A for secondary contacts
- strain relief, handle and bend protection
- Primary and secondary contacts
- Redundancy already in the plug
- Easily accessible contacts and solder joints
- Classic plug with secure locking
- Ready assembled with 3m cable (0,35mm²)
- kit with all parts and screws
- Dimension cover 13x63mm
- Plug weight 19g without cable
uniLIGHT UNICONNECT
The innovative uniCONNECT plug-in system works with solid blade and heavy-duty skirtings. Thanks to the new design, it is now finally possible to realise a high number of poles in a connector with a small size - currently up to 22 pins. In addition, more than 3000 mating cycles are possible with loads of up to 10A. Optimally realised for use with model making.
The male connectors also offer the advantage that all cables can be reliably and easily soldered without a plastic carrier melting. Strain relief, latching, handle and bend protection are also available. The contacts of the male connectors are always visible, which means that damage and dirt are immediately visible.
However, the greatest advantage of the system is that double redundancy for important control functions is already provided in the plug. For this reason, the system not only specifies conventional pin numbers, but distinguishes between primary pins (double, for main functions) and secondary pins (single, for light, chassis, brake, ...).
DIRECT CABLE
as the first group is a classical connection, where a socket is installed e.g. in the fuselage and the cables are led from the wing to a plug. During assembly, this plug is led into the socket and locks there. The remaining cable is pushed back into the wing.
RTR:
as a fully assembled and soldered unit with 2/3m cable directly connected 1 to 1. This is installed on one side, the length to the servo is defined and assembled with crimp contacts. The remaining cable is laid on the other side up to the receiver and assembled there. This finished unit is always delivered in one piece.
DIY:
as kit for the model builder with all parts and screws for your own construction. This makes it very attractive in price, always delivered as a pair of 2 pieces.
