Skip to main content

FREE SHIPPING from € 100,- / DE / AT

FREE SHIPPING: DE, AT... from 100,- € / CH ... from 199,- / FR, BE, BG, FR, IT, HR, NL ... from 299,- €

FREE SHIPPING from € 100,- / DE / AT

  • dot LED chip (green)
  • with 1m connection cable
  • Pre-assembled series resistor for 2S
  • resistor for 3S included



Reference power: 4W
Voltage [V]: 8V(12V)
Abmessungen: Ø20x7mm/Chip Ø8x5mm
Current [A]: 0,35A
Weight: 2g (ohne Kabel)
angle of reflected beam: ~140°
Color: Green
Luminosity: ~70 Lumen

dot LED chip in GREEN

High-power LED module with 4W reference power. Pre-assembled for operation with 2S Lipo (approx. 8V). When operating with 3S (12V), the enclosed resistor must be used. Alternatively, you can also use a 4W-3S adapter cable.

Please note that high-power LEDs can become very warm, up to 70°C is quite normal. However, these modules are only suitable for continuous operation if a heat sink is used. After installation, check the operating temperatures and use our heat sink housings, for example.

Information on the reference power is a pure comparison value between the lamps offered. They normally refer to an operating voltage of 12V/3S Lipo and depend on lamp, operating mode and technology.

Pay attention to the operating temperature, the manufacturer does not assume any warranty for overheating.

Attention: The LED lights are extremely bright! Never look directly into an LED!


Manufacturer and responsible person (information obligations under the GPSR Product Safety Regulation)

CSD e.U.
Flurgasse 16
3422 Altenberg
ÖSTERREICH
Tel: 06648408425
[email protected]

UNILIGHT 4W POINT-LIGHT-CHIP GREEN
Product number: 9708892
Manufacturer number: POINT-040-GN

€5.99*

% €8.50* (29.53% saved)

In stock. Usually ships within 1 business day.

  • dot LED chip (green)
  • with 1m connection cable
  • Pre-assembled series resistor for 2S
  • resistor for 3S included



Reference power: 4W
Voltage [V]: 8V(12V)
Abmessungen: Ø20x7mm/Chip Ø8x5mm
Current [A]: 0,35A
Weight: 2g (ohne Kabel)
angle of reflected beam: ~140°
Color: Green
Luminosity: ~70 Lumen

dot LED chip in GREEN

High-power LED module with 4W reference power. Pre-assembled for operation with 2S Lipo (approx. 8V). When operating with 3S (12V), the enclosed resistor must be used. Alternatively, you can also use a 4W-3S adapter cable.

Please note that high-power LEDs can become very warm, up to 70°C is quite normal. However, these modules are only suitable for continuous operation if a heat sink is used. After installation, check the operating temperatures and use our heat sink housings, for example.

Information on the reference power is a pure comparison value between the lamps offered. They normally refer to an operating voltage of 12V/3S Lipo and depend on lamp, operating mode and technology.

Pay attention to the operating temperature, the manufacturer does not assume any warranty for overheating.

Attention: The LED lights are extremely bright! Never look directly into an LED!


Manufacturer and responsible person (information obligations under the GPSR Product Safety Regulation)

CSD e.U.
Flurgasse 16
3422 Altenberg
ÖSTERREICH
Tel: 06648408425
[email protected]