dot LED chip in RED
High-power LED module with 4W reference power. Pre-assembled for operation with 2S Lipo (approx. 8V). When operating with 3S (12V), the enclosed resistor must be used. Alternatively, you can also use a 4W-3S adapter cable.
Please note that high-power LEDs can become very warm, up to 70°C is quite normal. However, these modules are only suitable for continuous operation if a heat sink is used. After installation, check the operating temperatures and use our heat sink housings, for example.
Information on the reference power is a pure comparison value between the lamps offered. They normally refer to an operating voltage of 12V/3S Lipo and depend on lamp, operating mode and technology.
Pay attention to the operating temperature, the manufacturer does not assume any warranty for overheating.
Attention: The LED lights are extremely bright! Never look directly into an LED!
