Basic module for indirect model lighting at night.

Brand new on the market we offer a system for night flight lighting, with which you can really see your model! The LED modules are pre-assembled on aluminium supports and these are attached directly to the edge arches (surface and on large models also to the tailplane) of the model to illuminate the model in flight from outside - a special night flying experience because the model is totally visible. Optimal in combination with a normal night flight lighting and a programmable control, wonderful lighting effects can be achieved.

The aluminium base support has different hole openings and can therefore be mounted at different distances. Depending on model, vibration and flying style an additional spar/reinforcement is necessary. The base carrier defines the distance and provides the necessary cooling for the high-performance LEDs. A CFRP tube or CFRP plate can simply be glued or screwed onto the aluminium. In addition, our Ploycarbonate caps can be used to protect the LED and improve light distribution.

The module is ready-made for operation with 2S Lipo (approx. 8V). When operating with 3S (12V), the enclosed resistor must be used. Alternatively, you can also use a 4W-3S adapter cable.

Please note that high-power LEDs can become very warm, up to 70°C is quite normal. However, these modules are only suitable for continuous operation if a heat sink is used. After installation, check the operating temperatures and use our heat sink housings, for example.

Information on the reference power is a pure comparison value between the lamps offered. They normally refer to an operating voltage of 12V/3S Lipo and depend on lamp, operating mode and technology.

Pay attention to the operating temperature, the manufacturer does not assume any warranty for overheating.

Attention: The LED lights are extremely bright! Never look directly into an LED!