Round light module in white, green or red. Used, for example, as position or anti-collision lighting.
variant description
- White variant: For use e.g. as position light/rear light or as collision warning light (strobe) in the area tips.
- Green variant: For use e.g. as a position light in the wingtip on the starboard side (right).
- Red variant: For use e.g. as position light in the wing tip on the port side (left) or as collision warning light (beacon) on the tail unit or on the fuselage.
connector
The lighting module can be connected directly to an SLC output (Smart Light Channel) of the Light Driver 5.0 lighting control system (see accessories). No soldering work and no series resistors are necessary.
Intelligent lighting control
- Plug & Play type recognition: The lighting module is automatically recognised by the Light Driver 5.0 lighting control system. The light control regulates the luminosity and thus the heat development according to the thermal properties of the module housing.
- MLT technology (Maximum Light Tracking): The light module can optionally be operated at full light output. An integrated heat sensor enables the Light Driver 5.0 lighting control system to automatically regulate the light output in the event of high heat generation.
interoperability
The light module can also be used in conjunction with the Optotronix light control modules. For this purpose, a 3.9 Ohm resistor (3R9) for the green or white version and a 10 Ohm resistor (10R) for the red version must be soldered into the positive or negative cable.
