DESCRIPTION
Latest 1/5 Car-HV-Servo. Supports the SR mode of the T7PX transmitter. Programmable and compatible with S.Bus and S.Bus2 systems. Can be connected and programmed to a PC using the separately available CIU-2 / -3 USB adapter. The gear wheel is now made of stainless steel. The toothing to the servo lever is also made of stainless steel, which means a significant increase in load capacity in the direction of force.

Due to the new housing geometry, a mechanically reinforced shaft output at the upper part of the housing has been realized. A high-quality brushless motor serves as drive.

Digital S.BUS2 ultra power servo with incredible 370 Ncm torque. The robust metal gear is mounted 4-fold, the housing 6-fold screwed. The housing is made of aluminium to optimise the gearbox stability and cooling of the motor. Despite the enormously high torque, the servo has extremely short operating times of 0.11s / 60°. The servo is designed for Hi-Voltage, so that power can be supplied directly from a 2s LiPo battery.

The housing is completely CNC-milled from aluminium and designed for maximum load.

Advantages of brushless motor technology:
- 30% shorter response time
- Better acceleration
- More resistant to vibrations and shocks
- High efficiency, thus less motor heating
- No carbon brush wear, thus 5 times the motor service life
- Special gearbox with maximum freedom from backlash
- Cobalt Samarium Motor Magnets
- Highest resolution
- Same power consumption as conventional digital servos

Programmable by S.BUS2 technology! Of course, all S.BUS2 servos can be connected to conventional receivers with PWM modulation. The servos can be addressed in various ways:

1 Via the S.BUS receiver
2. with the handy SBC-1 programmer
3. via the PC-Link software with the CIU-2 or CIU-3 USB adapter
4. at the S.BUS connection of the transmitter

The following parameters can be configured:
- S.BUS channel assignment
- Servo polarity
- Servo type (normal / retractable)
- Soft start (On / Off)
- Mode selection on signal failure Hold or Free
- Soft servo drive (on / off)
- Servo position (servo tester)
- Servo center adjustment +/- 300 µs (approx. 30 degrees)
- Servo speed, 0.39...9 seconds per 45 degrees
- Deadband setting (dead band)
- Servo travel adjustment left and right separate, approx. 50...175%
- starting power
- cushioning
- holding force
- ID storage