FEATURES
- Powerful S.BUS2 digital servo with metal housing and metal gearbox
- Brushless HPS motor
- Hi-Voltage
- Ball bearing
- High resolution
- High return accuracy
- Low-wear potentiometer
TECHNICAL DATA
- Operating voltage: 6,0 - 8,4 V
- Positioning speed 60° (7.4 V): 0.08 s
- Actuating torque (7.4 V): 20.0 kgcm
- Control frequency: 50...300 Hz
- dimensions: 40,5x21x37,8 mm
- Weight: 73 g


DESCRIPTION
The Futaba HPS-HC700 is the new high-performance servo for helicopter models that require medium actuating forces. 20 kgcm torque and 0,08 sec/60° operating time at 7,4V are a clear announcement. A new HPS brushless motor was developed for the HPS servos, which remains significantly cooler during operation. Together with the new HPS technology, this results in lower power consumption over the operating time. The new all-aluminium housing measures 40.5 x 21 x 37.8 mm. Like any S.BUS2 servo, the HPS-HC700 can be connected to all conventional receivers with PWM modulation. In addition, the characteristics of the servo can be optimally adapted to its operating conditions by programming.

Replaces the BLS273SV/275SV servos.

The servos can be addressed in various ways:

1. via the S.BUS receiver
2. with the handy programmer SBC-1
3. via the PC-Link software with the USB adapter CIU-3
4. at the S.BUS connection of the transmitter

The following parameters can be configured:
- S.BUS channel assignment
- servo reversal
- Soft start (On / Off)
- Mode selection in case of signal failure Hold or Free
- Soft servo run (on / off)
- Servo position (servo tester)
- Servo center adjustment +/- 300 µs (approx. 30 degrees)
- Servo speed, 0.39...9 seconds per 45 degrees.
- Deadband setting (dead band)
- Servo travel adjustment left and right separated, approx. 50...175%
- starting force
- attenuation
- holding force
- ID storage