The Servo Expander SE6 is a device that converts the serial bus signal into standard PWM servo outputs.
It provides up to six configurable servo outputs with optional output period and a fail safe setting.
The Servo Expander SE6 is ideal for reducing the wiring harness in the model to allow additional functions besides the flybarless system.
The SE6 is the perfect choice for models with complex wing or tail mechanics, as well as models with limited receiver outputs.
receiver outputs where multiple analog/digital servos can be connected to a primary receiver with only one cable.
with only one cable. If you need more receiver channels, simply connect the SE6
to the serial receiver line and freely assign the output channels.
Supported protocols:- Futaba: S.Bus/S.Bus2
- Graupner: SUMD, Hott telemetry with setting possibility at the transmitter
- JETI: EX Bus with setting possibility at the transmitter, via JETI Box emulator
- Multiplex: SRXL 12ch, SRXL 16ch
Features- for analog/digital servo
- no S-Bus servo needed
- small dimensions and high current throughput via integrated MR30 power connector
- Automatic detection of serial data / telemetry after startup
- Configuration via transmitter or external terminal (JETIBOX/SMART-BOX)
- Firmware updates via USB interface
Technical data:- Dimension (with connector) 33x19x9mm
- Weight (with connector) 5,4g
- Servo slots 5 or 6
- Operating current 15mA
- Temperature range -20 - 85°C
- Supply voltage 4 - 14V (recommended 5-8.4V)
- Continuous current up to 15A
- Peak current 60A (2sec)
- Supported protocols
- JETI Duplex
- Multiplex
- Graupner Hott
- Futaba S.Bus
- Status LED yes
