External switch
The Ibex BEC Controller allows you to use an external switch if necessary. By default, the switch is not present, so the cruise control/BEC turns on immediately after connecting the flight battery.
The type of switching element can be specified in the "General - switch type":
Mechanical (standard) - the switch closes the yellow (signal) and brown (ground) wire of the switch/button cable short. An inverted logic is used so that the ESC remains on when the switch is left open or not plugged in.
Button/Reverb - first long press turns ESC on; second long press turns it off. The LED indicates the on/off state and flashes when the magnet (or keystroke) is detected, the Hall sensor can be purchased as an ESC accessory.
Electronic - allows the installation of an external electronic switch (touch switch, RC switch, etc.). In this case, the switching device is always supplied with power and the logic level of the signal line indicates the on/off state to the control.
Note: Please pay attention to the parameters of an external switch before connecting. The signal line uses a 3.3 volt logic with a weak pull-up. The power supply of the ESC is designed for 10 V with a maximum current of 30 mA.
Note:
Please pay attention to the parameters of an external switch before connecting. The signal line uses a 3.3 volt logic with a weak pull-up. The power supply of the ESC is designed for 10 V with a maximum current of 30 mA.
Total weight Hall sensor with cable only 2 grams
If required, a servo cable extension can be inserted between the sensor and the IBEX controller
