The DPS-25 V2 is used to switch on a receiver system safely and without wear, to supply it with high current for best servo performance and at the same time to increase safety by using 2 separate receiver batteries for battery redundancy. Of course, the DPS-25 V2 can also be used with only one battery as a pure receiver switch.

In order to be able to use the optimal performance of powerful and fast servos at all, a power supply is required which leads the necessary, high currents directly to the servo sockets on the receiver without any losses.

In addition, the power supply must still function even if a battery fails. The DPS-25 provides these safety functions while at the same time minimising components that are susceptible to failure. This results in optimal protection against vibration and contact problems. The switching output stages used ensure maximum and loss-free current flow; the internal resistance is considerably lower than the contact resistance of mechanical switches.

This version is supplied as a pure circuit board with heat shrink tubing without cables and connectors.

NOTE: Input voltage = output voltage, no voltage reduction, the servos are supplied directly with the battery voltage!

Technical data
- Input voltage 4.5 - 8.4 V
- Total power: up to 300 W
- Weight: 25 g
- Dimensions: 46x17x11 mm

Features
- Battery backer with electronic safety switches
- High current power FETs for 25A continuous current (40A short) with lowest internal resistance in the switch.
- LED indicator for each battery
- 0.5 sec safe interruption bridging against switch bounce and vibration
- Absolutely vibration-proof due to SMD technology
- No mechanical wear
- Ideal for all applications with powerful digital and power servos
- Servo power supply from 1 or 2 high-current batteries
- Voltage drop max. 0.2V at 20A
- Automatic switchover if one battery fails
- Only passive, fail-safe electronic components, no software