TelemetryVoltario T30
Voltario T30 combines the touch-switch function with the telemetry sensor for your model in a single device.
Voltario T30 is suitable for switching the electronics in your model on and off. When using a receiver battery, the Voltario T30 can directly replace the mechanical switch. Especially for thin glider fuselages or models equipped with a small BEC circuit, the unit offers great advantages such as a small size in addition to monitoring the receiver power supply. The unit remembers its last operating state and restarts automatically after connecting the power supply.
Touch switch function
Duplex telemetry (current, voltage, capacity)
HOTT telemetry (current, voltage, capacitance)
Futaba telemetry (1678 Port3 - current, voltage, capacitance)
Optional undervoltage cut-off
JetiBox compatible
Voltario T30 installation:
Plug the unit between the receiver and the battery. If you are using a BEC, plug the Voltario between the battery and the BEC. Remember that in this case you must disconnect the red cable from the Voltario telemetry connector.
Touch switch:
Place the touch button anywhere on your model's surface of non-conductive material. You can also place the touch button in the fuselage with a maximum thickness of up to 3 mm.
The status LED should be visible outside the fuselage.
Stick the "Touch" sticker on the touch surface.
Connect the receiver battery to the Voltario and briefly touch the button.
The status LED should flash once. If not, please increase the touch sensitivity parameter in the configuration.
Touch and hold the key for about 2 seconds. After the first flashing, the LED starts flashing again.
At this moment, release the key. The main output is now activated:
- Voltario T30
- Dimensions 25x12x5mm
- Weight incl. cable 9g
- Continuous current max. 10A
- Peak current (2s) 30A
- Temperature range -20 - 85
- Operating voltage 4-12V
- Telemetry Jeti Duplex, Hott, Futaba
- Overcurrent fuse yes
- Cable 0,5mm² (20AWG)
