The Central Box 320 is designed for a complete management of multiple servos and two receiver batteries for a model with high security requirements. The Central Box 320 has an overload protection on each servo output, 8 channels for high-performance servos up to 60 kg / cm and 10 channels for standard servos up to 30 kg / cm. Especially for the use of powerful and power-hungry servos, the Central Box 320 has an aluminum housing for better cooling. The Central Box 320 offers true battery redundancy, DITEX servo telemetry, JETI EX telemetry and up to three receiver inputs (2x 2.4GHz and 1x 900MHz) for full power and RF signal redundancy.

Configuration via JETI Duplex DS/DC transmitters
With JETI Duplex DC/DS transmitters, the full potential of the Central Box 320 can be fully exploited. The device overview of the JETI Duplex DS/DC transmitter makes it easy to perform the entire configuration of the servo outputs, DITEX servo and JETI EX telemetry, function assignment, and more.

Compatibility with Futaba
The Central Box 320 can also be used with two S.Bus receivers (e .g Futaba R7003SB). Setting up and reading out the telemetry values must, however, be realized with a separatly available JETIBOX.

Switching on and off
The switching on and off process of the Central Box 320 is done with the supplied magnetic switch.

Recommended receivers
As receiver e. g. 2 RSat2 or REX3 receivers can be used. Optionally, the use of a REX Assist receiver in combination with a RSat2 receiver is possible, so you get a Central Box with gyro stabilization.

Features

• Adjustable powerful BEC for voltage stabilization (connection of standard or HV servos)
• DITEX servo telemetry support
• Possibility to connect up to 3 receivers with serial communication
• built-in Expander function with the possibility of independent connection of up to four JETI EX sensors
• Input for magnetic switch or RC switch
• Power supply batteries connected via MPX connector
• 100Hz mode of servo outputs (10ms period)
• EX telemetry support (measurement of voltage, current, capacity, temperature, etc.)
• Easy settings changes via DC/DS transmitter („Device explorer“)
• Robust metal construction with mounting holes